Product Details & Fitment
This Bentley Arnage front and rear ABS sensor kit is made for the 1998–2002 Bentley Arnage Green Label, Bentley Arnage Red Label and Rolls-Royce Silver Seraph. The kit includes four brand-new wheel speed sensors, two front (left and right) and two rear (left and right), made by the original equipment manufacturer and matching Bentley and Rolls-Royce part numbers PC21080PA (front) and PC21081PA (rear).
Each ABS sensor reads the speed of its wheel and sends that signal to the ABS control module. The module uses it to stop the wheels from locking under hard braking, and the same signals support the traction control and the speedometer on these cars. Replacing all four sensors at once restores an even, accurate signal from every corner of the car.
Common signs of a failing ABS sensor include the ABS or brake warning light staying on, the anti-lock system activating at low speed or on dry roads, a jumpy or dead speedometer, and fault codes for a wheel speed signal. On cars of this age, sensors often fail from corroded connectors, damaged wiring near the hub, or worn sensor tips.
These sensors are a direct replacement for the factory units and fit without modification. During installation, clean the sensor mounting bore and the tone ring, route the cable along the original path and secure it in all of its clips, then clear any stored ABS fault codes with a suitable diagnostic tool. Professional installation is recommended.
Please send us your vehicle's VIN before ordering so we can confirm these sensors are correct for your car.







