Bentley Continental GT, GTC & Flying Spur Front Control Arm Kit (8 Pieces)

This aftermarket 8-piece front control arm kit replaces every upper and lower front arm on the Bentley Continental GT, GTC and Flying Spur in one job. Replacing the full set restores tight steering and a quiet front end, and you avoid paying for the same labor twice when the next worn arm shows up.

The kit includes the front upper forward control arms left and right (3W0407505 and 3W0407506), the front upper rearward control arms left and right (3W0407509 and 3W0407510), the front lower rearward control arms left and right (3W0407693 and 3W0407694), and two front lower forward track control arms (3W0407151).

This kit fits the Bentley Continental GT, Continental GTC and Flying Spur on the 3W chassis from 2004 to 2017, with both W12 and V8 engines.

The control arms connect the front wheel hubs to the body. They hold the wheels in alignment and carry the weight of the car through every bump and corner. These are heavy cars, so the bushings and ball joints wear faster than on lighter vehicles.

Signs of worn control arms include a clunk or knock from the front over bumps, vague or wandering steering at highway speed, a steering wheel that shakes under braking, and uneven wear on the inner or outer edge of the front tires.

Installation tip: do not torque the mounting bolts while the wheels are hanging in the air. Lower the car to its normal ride height on a drive-on lift or ramps, then do the final torque. Tightening at full droop twists the rubber bushings and tears them early. Get a four-wheel alignment once the job is done.

Send us your VIN before ordering and we will confirm this kit fits your car.